The Haltech CAN Adaptor Loom (HT-130046) is a short braided harness with a Deutsch DTM-4 CAN connector on one end and flying leads on the other. Use it to connect a Haltech CAN device straight to the CAN and power pins on the main connector of many aftermarket ECUs.

Why you need it

Haltech CAN devices like the iC-7 dash and the WB1/WB2 wideband controllers use a DTM-4 CAN connector. Many aftermarket ECUs bring CAN and power out through an AMP Superseal 1.0 series connector. This loom joins the two, so you can add a Haltech CAN accessory to your ECU without building a harness from scratch.

Features

• Deutsch DTM-4 connector to suit Haltech CAN devices
• Flying leads terminated with 2 x pins to suit the AMP Superseal 1.0 series connector
• Braided wire sleeve for protection and a clean install
• Quick, tidy install for your CAN accessory

Compatibility

• Haltech iC-7 dash
• Haltech WB1 and WB2 CAN wideband controllers
• Aftermarket ECUs that use the AMP Superseal 1.0 series connector for CAN and power

CAN and power pin locations vary by ECU. Always check your ECU's wiring diagram before you connect it.

What's in the box

• 1 x HT-130046 CAN Adaptor Loom (DTM-4 to flying leads)

Not sure which CAN adaptor fits your setup? Contact Kugan Tuning with your ECU and dash or wideband model, and we'll point you to the right part.